Then you can dim down to the level of choice.This will lower the delay of lighting when you turn the dimmer switch on when you enter the room.We listed 3 example dimmers and since then we have a list of alternate dimmers that we have tested that work better. ![]() Read on and see the alternate dimmer list below.*LED dimmers start up with the lowest range of 25-30%, and this is normal for dimming LED fixtures.*We suggest leaving the dimmer on "high" when you turn off the switch so that it will start off on high receiving the full amount of electricity to begin with. Yes, it is normal for some humming to occur when dimming LED fixtures. We apologize for the problems that you are having dimming your new fixture. You can also watch our Good Earth Lighting YouTube tutorials. Try connecting near the router, with the strip unrolled and elevated for first pairing. You can also use the auto scan feature to see if the fixture pops up and pair that way. You can also try restarting/resetting your mode or router and uninstalling and reinstalling the app. The fixture needs to be rapidly flashing while in pairing mode in order to connect and you must be on the same Wi-Fi network you are trying to connect to. If your router switches between 2.4ghz and 5.0ghz and you are unable to connect, reach out to your ISP to ensure you've switched to 2.4ghz. If you are unsure if you are in 2.4ghz or how to switch to 2.4ghz, contact your internet service provider. Are you unable to connect to the app?Īre you in 2.4ghz or 5.0ghz? Internet must be in 2.4ghz to connect to the Good Earth app. These lights are controlled via the Good Earth Lighting app. Please disconnect and reconnect all components and try again. Pressing any of the other color buttons will switch the tape light to the color of the button pressed. To dim, or brighten your color LED’s, press, and hold down the dimming or brighten buttons until reaching the desired light output. Use the “ON” or “OFF” buttons in this section to turn on the color LED’s. The buttons at the bottom of the remote control, apply festive, and changing light by cycling through color with varying degrees of fades and jumping light changes. Press the 25%, 50%, 75%, or 100% buttons to immediately adjust the white LED’s to these varying levels of brightness. To dim, or brighten your white LED’s, hold down the dimming, or brighten buttons until reaching the desired light output. The buttons located on the white background control the brightness and intensity of white LED light output. WHITE LED’S Press the “ON” or “OFF” button to turn the white LED’s on, or off. I will do some further checking into that.The buttons located on the black background at the top of the remote control, adjust the intensity and multi-color variations of the color LED’s output. There used to be a glitch where light groups activated by cameras would not follow the auto-shutoff time setting and would only stay on for a shorter period of time, and I don’t know if that’s been resolved. The only part I didn’t verify was whether the bulb would stay at maximum brightness for the entire auto-shutoff time set in the light group. ![]() With that configuration the bulb is at the lowest brightness normally but will ramp up to max brightness whenever the doorbell detects motion. ![]() In there I set it to turn on the light group that my A19 bulb is in whenever motion detected. ![]() Then I went into the doorbell configuration and went into Linked Devices. After doing that, I went back into the A19 bulb configuration and made sure the brightness slider was at the maximum. I created a light schedule for the A19 bulb and set the brightness in the schedule to the lowest setting. I was able to get this to work, although I have slightly different hardware (A19 bulb and Doorbell 2020 version) so maybe it doesn’t work under all configurations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |